Rohde & Schwarz Scope Rider RTH1004 - Runt Trigger (R&SRTH-K19)

Remote Control Commands
R&S
®
Scope Rider RTH
322User Manual 1326.1578.02 ─ 12
TRIGger:STATe:COMBination <ChCombination>
Sets the logical combination for all active channels. The required state of each channel
is defined by TRIGger:PATTern:STATe[:CHANnel<m>].
Parameters:
<ChCombination> AND | OR
*RST: AND
TRIGger:STATe:CSOurce[:VALue] <Source>
Sets the input channel of the clock signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:STATe:CSOurce:EDGE
<Slope>
Sets the edge of the clock at which the instrument checks the signal states.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
15.3.5.9 Runt Trigger (R&S RTH-K19)
See also Chapter 3.6.9, "Runt Trigger (R&S RTH-K19)", on page 65.
TRIGger:LEVel<m>:RUNT:LOWer................................................................................... 322
TRIGger:LEVel<m>:RUNT:UPPer.................................................................................... 322
TRIGger:RUNT:POLarity.................................................................................................323
TRIGger:RUNT:RANGe.................................................................................................. 323
TRIGger:RUNT:WIDTh................................................................................................... 323
TRIGger:RUNT:DELTa....................................................................................................324
TRIGger:RUNT:MINWidth............................................................................................... 324
TRIGger:RUNT:MAXWidth.............................................................................................. 324
TRIGger:LEVel<m>:RUNT:LOWer <Level>
TRIGger:LEVel<m>:RUNT:UPPer <Level>
Set the upper and lower levels that limit the runt.
Suffix:
<m>
.
1..4
Indicates the trigger source: analog channel 1 to 4
Waveform Setup