Rohde & Schwarz Scope Rider RTH1004 - Waveform Analysis

Remote Control Commands
R&S
®
Scope Rider RTH
334User Manual 1326.1578.02 ─ 12
Parameters:
<MinDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:WINDow:MAXWidth <MaxDuration>
Sets the upper time limit of the stay inside or outside the window (comparisons WITHin
and OUTSide).
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
15.4
Waveform Analysis
15.4.1 Zoom
See also Chapter 4.1, "Zoom", on page 77.
ZOOM:ENABle.............................................................................................................. 334
ZOOM:SCALe............................................................................................................... 334
ZOOM:POSition.............................................................................................................335
ZOOM:ENABle <Enabled>
Enables or disables the zoom.
Parameters:
<Enabled> ON | OFF
*RST: OFF
ZOOM:SCALe <Scale>
Sets the time scale of the zoomed waveform.
Depending on the recording time not all horizontal scales are available. This is due to
the fact that, the zoom is always displaying a complete curve.
Parameters:
<Scale> Range: 1E-12 to 500
Increment: 1E-12
*RST: 100E-9
Default unit: s
Waveform Analysis