Rohde & Schwarz Scope Rider RTH1004 - Display and Control

Frequency Counter (R&S RTH-K33)
R&S
®
Scope Rider RTH
257User Manual 1326.1578.02 ─ 12
11.2 Display and Control
1
7
8
10
11
12
13
2 3
4 5 6
9
14
15
Figure 11-1: Display for basic counter
1 = Measurement state. "Manual": running measurement with manual range; "Hold": stopped measure-
ment
2 = Vertical settings for channel 1 (incl. "Probe Setting")
3 = Vertical settings for channel 2 (incl. "Probe Setting")
4 = Minimum frequency and timestamp
5 = Average frequency
6 = Maximum frequency and timestamp
7 = Currently measured frequency
8 = Bargraph indicating the load level of the A/D converter for the selected measurement range; for val-
ues ≥ 100 %, an overload warning is displayed; for optimal results the load level should be above
20 %;
9 = Counter on/off switch
10 = Used reference (Internal or Counter 2)
11 = Restarts the measurement and resets all values
12+13 = Measurement ranges of active channels
14 = Channel input selection
15 = Counter selection
Display and Control