Rohde & Schwarz Scope Rider RTH1004 - Edge Trigger; Glitch Trigger; Trigger:holdoff:events; Trigger:holdoff:max

To Next Page

To Previous Page

Remote Control Commands

R&S

Scope Rider RTH

312User Manual 1326.1578.02 ─ 12

TRIGger:HOLDoff:EVENts <Events>

Sets the number of triggers to be skipped until the next trigger occurs. The command

takes effect if TRIGger:MODE is set to EVENts.

Parameters:

<Events> Range: 1 to 1000000000

Increment: 10

*RST: 1

TRIGger:HOLDoff:MIN

TRIGger:HOLDoff:MAX <RandomMaxTime>

Set the time limits for random holdoff time. For each acquisition, the instrument selects

a new random holdoff time from the specified range.

Parameters:

Range: 8E-9 to 10

Increment: 200E-6

*RST: 2E-3

Default unit: s

TRIGger:MNR <MoreNoiseReject>

Enables a hysteresis to avoid unwanted trigger events caused by noise oscillation

around the trigger level.

Parameters:

<MoreNoiseReject> ON | OFF

*RST: OFF

15.3.5.2 Edge Trigger

TRIGger:EDGE:SLOPe <Slope>

Sets the edge to be triggered on.

Parameters:

<Slope> POSitive | NEGative | EITHer

POSitive = rising edge

NEGative = falling edge

EITHer = rising and falling edge

*RST: POSitive

15.3.5.3 Glitch Trigger

See also: Chapter 3.6.3, "Glitch Trigger", on page 54

Waveform Setup

Other manuals for Rohde & Schwarz Scope Rider RTH1004