Rohde & Schwarz Scope Rider RTH1004 - Data2 Clock Trigger (R&SRTH-K19)

Remote Control Commands
R&S
®
Scope Rider RTH
326User Manual 1326.1578.02 ─ 12
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:SLEW:DELTa <Tolerance>
Sets a range Δt to the specified slew rate, which is defined using TRIGger:SLEW:
RATE.
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
TRIGger:SLEW:MINWidth <MinDuration>
Sets the lower time limit of the transition time for comparisons WITHin and OUTSide.
Parameters:
<MinDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:SLEW:MAXWidth <MaxDuration>
Sets the upper time limit of the transition time for comparisons WITHin and OUTSide.
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
15.3.5.11 Data2Clock Trigger (R&S RTH-K19)
See also Chapter 3.6.11, "Data2Clock Trigger (R&S RTH-K19)", on page 68.
TRIGger:DATatoclock:DSOurce[:VALue]...........................................................................327
TRIGger:DATatoclock:CSOurce[:VALue]...........................................................................327
TRIGger:DATatoclock:CSOurce:EDGE.............................................................................327
TRIGger:DATatoclock:CONDition.....................................................................................327
TRIGger:DATatoclock:HTIMe...........................................................................................327
TRIGger:DATatoclock:STIMe...........................................................................................328
Waveform Setup