Rohde & Schwarz Scope Rider RTH1004 - Slew Rate Trigger (R&SRTH-K19)

Remote Control Commands
R&S
®
Scope Rider RTH
324User Manual 1326.1578.02 ─ 12
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:RUNT:DELTa <Tolerance>
Sets a range Δt to the specified width, which is defined using TRIGger:RUNT:WIDTh.
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
TRIGger:RUNT:MINWidth
<MinDuration>
Sets the lower time limit of the runt for comparisons WITHin and OUTSide.
Parameters:
<MinDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:RUNT:MAXWidth <MaxDuration>
Sets the upper time limit of the runt for comparisons WITHin and OUTSide.
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
15.3.5.10 Slew Rate Trigger (R&S RTH-K19)
See also Chapter 3.6.10, "Slew Rate Trigger (R&S RTH-K19)", on page 67.
TRIGger:LEVel<m>:SLEW:LOWer...................................................................................325
TRIGger:LEVel<m>:SLEW:UPPer....................................................................................325
TRIGger:SLEW:SLOPe.................................................................................................. 325
TRIGger:SLEW:RANGe..................................................................................................325
TRIGger:SLEW:RATE.....................................................................................................325
TRIGger:SLEW:DELTa................................................................................................... 326
TRIGger:SLEW:MINWidth...............................................................................................326
TRIGger:SLEW:MAXWidth..............................................................................................326
Waveform Setup