Rohde & Schwarz Scope Rider RTH1004 - Logic Analyzer (R&S RTH-B1 MSO)

Remote Control Commands
R&S
®
Scope Rider RTH
486User Manual 1326.1578.02 ─ 12
Suffix:
<m>
.
*
Return values:
<FrameType> TRSQ | SMSG | EMSG
TRSQ = transmission sequence
SMSG = short serial message
EMSG = enhanced serial message
*RST: TRSQ
Usage: Query only
15.12 Logic Analyzer (R&S RTH-B1 MSO)
LOGic:STATe.................................................................................................................486
LOGic:THCoupling......................................................................................................... 486
LOGic:GROup<m>:TECHnology..................................................................................... 486
LOGic:GROup<m>:USER...............................................................................................487
LOGic:GROup<m>:THReshold?......................................................................................488
LOGic:GROup<m>:HYSTeresis.......................................................................................488
LOGic:CHANnel<m>:DESKew........................................................................................ 488
POD:STATe?................................................................................................................. 489
LOGic:STATe <State>
Enables or disables the logic channels.
Parameters:
<State> ON | OFF
*RST: OFF
LOGic:THCoupling <ThresCoup>
Couples the threshold and hysteresis settings for the logic channels.
If enabled, all logic channels use the same threshold and hysteresis settings.
If disabled, 2 channel groups are available, which can use different threshold and hys-
teresis settings: D0 - D3, and D4 - D7.
Parameters:
<ThresCoup> ON | OFF
*RST: ON
LOGic:GROup<m>:TECHnology <ThresholdType>
Sets the threshold value for the selected channel group, or for all logic channels.
Logic Analyzer (R&S
RTH-B1 MSO)