Rohde & Schwarz Scope Rider RTH1004 - Analyzing Logged Data

Data Logging
R&S
®
Scope Rider RTH
161User Manual 1326.1578.02 ─ 12
Remote command:
LOGGer:SLOT:CURRent on page 414
Slot Name
Enter an optional slot name to describe the logged data. The maximum length of the
name is 20 characters.
Remote command:
LOGGer:SLOT:SLOT<m>:NAME on page 414
Load Slot
Loads the stored log data of the selected slot.
Only possible while logging is stopped.
Remote command:
LOGGer:SLOT:LOAD on page 415
LOGGer:SLOT:SLOT<m>:HASData? on page 414
Clear Slot
Deletes the log data of the selected slot.
Only possible while logging is stopped.
Remote command:
LOGGer:SLOT:CLEar on page 415
Clear All Slots
Deletes the log data of all slots.
Only possible while logging is stopped.
Remote command:
LOGGer:ACLR on page 415
8.5 Analyzing Logged Data
You can analyze logged data using the "Cursor" and the "Zoom". To analyze logged
data at a later time, the data is stored automatically, and you can load the stored data
to the display.
8.5.1 Cursor
To analyze logged data, you can use cursor measurements, see also Chapter 4.3,
"Cursor Measurements", on page 85.
Analyzing Logged Data