Data Logging
R&S
®
Scope Rider RTH
162User Manual 1326.1578.02 ─ 12
Figure 8-3: Logger display with cursors
1 = Values of the crossings between the selected cursor line and the waveform
2 = Cursor lines
3 = Absolute value of the time difference between the cursor lines Δt = |t1-t2|
4 = Position of the cursor line 2
5 = Position of the cursor line 1
6 = Time stamp of the logged signal on the left side of the display
To select one of the two cursor lines, tap a cursor line, or use the wheel to navigate
and select. The selected line is highlighted by a bold line.
Remote commands for cursor results:
●
LOGGer:CURSor<m>:RESult<n>[:AMPLitude]? on page 419
●
LOGGer:CURSor:RESult<n>:DELTa? on page 419
●
LOGGer:CURSor<m>:POSition on page 420
●
LOGGer:CURSor:TDELta? on page 420
The logger cursor only allows you to set a "Cursor Value". The cursor settings "Type"
and "Source" are not relevant for logging, and thus not available
Description of settings
Access: "Cursor" menu
Analyzing Logged Data
To Next Page
Loading...
