Rohde & Schwarz Scope Rider RTH1004 - Spectrum Analysis

Remote Control Commands
R&S
®
Scope Rider RTH
352User Manual 1326.1578.02 ─ 12
MASK:ELAPsedtime[:SECS]?
Returns the test duration in seconds.
Return values:
<Sec> Time in seconds
Usage: Query only
15.6 Spectrum Analysis
● FFT Mode..............................................................................................................352
● Spectrum Mode (R&S RTH-K18)..........................................................................355
● Harmonic Mode (R&S RTH-B34)..........................................................................366
15.6.1 FFT Mode
To activate FFT mode, use OP FFT (see OP[:MODE] on page 298).
SPECtrum:SOURce....................................................................................................... 352
SPECtrum:FREQuency:BANDwidth[:RESolution][:VALue]..................................................352
SPECtrum:FREQuency:CENTer...................................................................................... 353
SPECtrum:FREQuency:HORizontal:SCALe......................................................................353
SPECtrum:FREQuency:MAGNitude:SCALe......................................................................353
SPECtrum:FREQuency:SAMPle?.................................................................................... 353
SPECtrum:FREQuency:SPAN:MODE.............................................................................. 354
SPECtrum:FREQuency:SPAN[:VALue].............................................................................354
SPECtrum:FREQuency:STARt........................................................................................ 354
SPECtrum:FREQuency:STOP.........................................................................................354
SPECtrum:FREQuency:WINDow:FACTor?....................................................................... 355
SPECtrum:FREQuency:WINDow:TYPE........................................................................... 355
SPECtrum:SOURce <Source>
Selects the channel for which the captured data is analyzed in FFT mode.
Parameters:
<Source> C1 | C2 | C3 | C4
*RST: C1
SPECtrum:FREQuency:BANDwidth[:RESolution][:VALue]
Queries or defines the used resolution bandwidth. The value depends on the
SPECtrum:FREQuency:SPAN:MODE and CHANnel<m>:BANDwidth parameters.
In FFT mode, this command is query only.
Spectrum Analysis