Rohde & Schwarz Scope Rider RTH1004 - Protocol Analysis

Remote Control Commands
R&S
®
Scope Rider RTH
425User Manual 1326.1578.02 ─ 12
LOGGer:SLOT:ACTive?
Returns the active, loaded slot. In stop mode, the loaded (active) slot and selected
(current) slot can differ. In run mode, the slots are the same, and this command shows
the same as LOGGer:SLOT:CURRent.
Return values:
<LoadedSlot> SLOT1 | SLOT2 | SLOT3 | SLOT4 | SLOT5 | SLOT6 | SLOT7 |
SLOT8 | SLOT9 | SLOT10
*RST: SLOT1
Usage: Query only
LOGGer:SLOT:EXPort:NAME <Name>
Sets the file name, file format and path to save the logger record.
Parameters:
<Name> String with path and file name with extension .csv or .mat.
LOGGer:SLOT:EXPort:SAVE
Saves the logger record of the active slot to the file specified with LOGGer:SLOT:
EXPort:NAME. The active slot is queried with LOGGer:SLOT:ACTive?.
Example:
RUN
LOGGer:SLOT:CURRent SLOT2
STOP
LOGGer:SLOT:ACTive?
<-- SLOT2
LOGGer:SLOT:EXPort:NAME '/media/USB1/SLOT2.MAT"
LOGGer:SLOT:EXPort:SAVE
Usage: Event
15.11 Protocol Analysis
● General Protocol Settings..................................................................................... 426
● I2C (Option R&S RTH-K1).................................................................................... 426
● SPI (Option R&S RTH-K1)....................................................................................436
● UART/RS-232/RS-422/RS-485 (Option R&S RTH-K2)........................................ 444
● CAN (Option R&S RTH-K3/R&S RTH-K9)............................................................450
● LIN (Option R&S RTH-K3).................................................................................... 465
● SENT (Option R&S RTH-K10).............................................................................. 474
Protocol Analysis