Rohde & Schwarz Scope Rider RTH1004 - Page 426

Remote Control Commands
R&S
®
Scope Rider RTH
426User Manual 1326.1578.02 ─ 12
15.11.1 General Protocol Settings
BUS:TYPE.................................................................................................................... 426
BUS[:STATe]..................................................................................................................426
BUS:FORMat................................................................................................................ 426
BUS:TYPE <Protocol>
Defines protocol type of the bus for configuration and trigger settings.
Parameters:
<Protocol> I2C | SPI | UART | CAN | LIN | SENT
*RST: I2C
BUS[:STATe] <State>
Enables the decoding and the display of the serial bus data.
Parameters:
<State> ON | OFF
*RST: OFF
BUS:FORMat <NumberFormat>
Sets the decoding format of the data.
Parameters:
<NumberFormat> BIN | OCT | DEC | HEX | ASCii
*RST: HEX
15.11.2 I2C (Option R&S RTH-K1)
● I2C Configuration Settings.................................................................................... 426
● I2C Trigger............................................................................................................ 428
● I2C Decode Results.............................................................................................. 430
15.11.2.1 I2C Configuration Settings
BUS:I2C:SCL:SOURce...................................................................................................427
BUS:I2C:SDA:SOURce.................................................................................................. 427
BUS:I2C:TECHnology.................................................................................................... 427
BUS:I2C:SCL:THReshold............................................................................................... 427
BUS:I2C:SDA:THReshold...............................................................................................427
BUS:SETReflevels......................................................................................................... 427
Protocol Analysis