EasyManua.ls Logo

Rohde & Schwarz Scope Rider RTH1004 - Window Trigger (R&SRTH-K19)

Rohde & Schwarz Scope Rider RTH1004
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Control Commands
R&S
®
Scope Rider RTH
332User Manual 1326.1578.02 ─ 12
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
15.3.5.15 Window Trigger (R&S RTH-K19)
TRIGger:LEVel<m>:WINDow:LOWer............................................................................... 332
TRIGger:LEVel<m>:WINDow:UPPer................................................................................332
TRIGger:WINDow:TIME..................................................................................................332
TRIGger:WINDow:RANGe.............................................................................................. 333
TRIGger:WINDow:WIDTh............................................................................................... 333
TRIGger:WINDow:DELTa................................................................................................333
TRIGger:WINDow:MINWidth........................................................................................... 333
TRIGger:WINDow:MAXWidth..........................................................................................334
TRIGger:LEVel<m>:WINDow:LOWer <Level>
TRIGger:LEVel<m>:WINDow:UPPer <Level>
Set the upper and lower voltage thresholds for the window trigger, respectively. The
trigger levels are the vertical window limits.
Suffix:
<m>
.
1..4
Indicates the trigger source: analog channel 1 to 4
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:WINDow:TIME <Condition>
Selects how the time limit of the window is defined.
Parameters:
<Condition> LONGer | SHORter | EQUal | NEQual | WITHin | OUTSide
LONGer | SHORter
Triggers if the signal crosses the upper or lower level after/
before the time "Width" defined by TRIGger:WINDow:WIDTh
EQUal | NEQual
Triggers if the signal stays inside or outside the vertical window
limits for a time equal/uneuqal to "Width" "±Tolerance" defined
by TRIGger:WINDow:WIDTh and TRIGger:WINDow:DELTa.
WITHin
Triggers if the signal stays inside or outside the vertical window
limits for a time "Min Width" AND "Max Width".
Waveform Setup

Table of Contents

Other manuals for Rohde & Schwarz Scope Rider RTH1004

Related product manuals