Getting Started
R&S
®
Scope Rider RTH
17User Manual 1326.1578.02 ─ 12
2.3 Instrument Tour
2.3.1 Front View
Figure 2-2: Front panel of the R&S
RTH1002
1 = Touch display
2 = Waveform setup with [AUTOSET], reset to default with [PRESET]
3 = Analysis functions
4 = Mode selection
5 = Save/Recall
6 = Instrument settings
7 = Power on/off
8 = Navigation controls
9 = Horizontal settings
10 = Run/stop acquisition and trigger settings
11 = Acquisition settings
12 = Screenshot and documentation output
13 = Channels and vertical settings
14 = Multimeter measurements
Instrument Tour
To Next Page
Loading...
