Rohde & Schwarz Scope Rider RTH1004 - Page 436

Remote Control Commands
R&S
®
Scope Rider RTH
436User Manual 1326.1578.02 ─ 12
VOID
The frame is empty.
ADNack
Missing acknowledge bit after address - no slave recognizes the
address.
WRNack
Missing acknowledge bit after written data - the addressed slave
does not accept the written data.
SPERror
Stop error, no stop condition found.
STERror
Start error, no start condition found.
INSufficient
The frame is not completely contained in the acquisition. The
acquired part of the frame is valid.
*RST:
OK
Usage: Query only
BUS:I2C:FRAMe<m>:STOP?
Returns the end time of the specified frame.
Suffix:
<m>
.
*
Return values:
<StopTime> Range: -100E+24 to 100E+24
Increment: 100E-12
*RST: 0
Default unit: s
Usage: Query only
15.11.3 SPI (Option R&S RTH-K1)
15.11.3.1 SPI Configuration Settings
BUS:SPI:SCLK:SOURce................................................................................................ 437
BUS:SPI:SSEL:SOURce.................................................................................................437
BUS:SPI:MOSI:SOURce.................................................................................................437
BUS:SPI:MISO:SOURce.................................................................................................437
BUS:SPI:SCLK:SLOPe...................................................................................................437
BUS:SPI:SSEL:POLarity.................................................................................................437
BUS:SPI:TECHnology.................................................................................................... 437
BUS:SPI:SCLK:THReshold............................................................................................. 438
BUS:SPI:SSEL:THReshold............................................................................................. 438
Protocol Analysis