Rohde & Schwarz Scope Rider RTH1004 - Page 474

Remote Control Commands
R&S
®
Scope Rider RTH
474User Manual 1326.1578.02 ─ 12
Example:
BUS:LIN:FRAMe2:SYMBol?
Response: Temperature
Usage: Query only
BUS:LIN:FRAMe<m>:SYSTate?
Returns the synchronization state of the frame.
Suffix:
<m>
.
*
Return values:
<FrameSyncState> OK | STERror | SPERror | PRERror | UVAL | NOEXists |
INSufficient
OK
The frame is valid.
SPERror
Stop error, no stop condition found
STERror
Start error, no start condition found
PRERror
Parity error, which indicates a transmission error
UVAL
Unexpected value
NOEXists
Byte does not exist
INSufficient
The frame is not completely contained in the acquisition. The
acquired part of the frame is valid.
*RST:
OK
Usage: Query only
15.11.7 SENT (Option R&S RTH-K10)
● SENT Configuration Settings................................................................................ 474
● SENT Trigger........................................................................................................ 478
● SENT Decode Results.......................................................................................... 480
15.11.7.1 SENT Configuration Settings
BUS:SENT:DATA:SOURce..............................................................................................475
BUS:SENT:POLarity.......................................................................................................475
BUS:SENT:TECHnology................................................................................................. 475
BUS:SENT:DATA:THReshold.......................................................................................... 475
BUS:SENT:CLKPeriod....................................................................................................476
BUS:SENT:CLKTolerance............................................................................................... 476
Protocol Analysis