Rohde & Schwarz Scope Rider RTH1004 - Page 335

Remote Control Commands
R&S
®
Scope Rider RTH
335User Manual 1326.1578.02 ─ 12
ZOOM:POSition <Position>
Sets the center position of the zoomed area in relation to the trigger point.
Parameters:
<Position> Range: -500 to 500
Increment: 1E-12
*RST: 0
Default unit: s
15.4.2 Automatic Measurements
In remote commands for automatic measurements, the suffix <m> defines the mea-
surement index. You can perform up to four different measurements simultaneously.
● Measurement Settings.......................................................................................... 335
● Measurement Results........................................................................................... 337
15.4.2.1 Measurement Settings
MEASurement<m>:ENABle............................................................................................ 335
MEASurement<m>:SOURce........................................................................................... 335
MEASurement<m>:TYPE............................................................................................... 336
MEASurement<m>:AOFF............................................................................................... 336
MEASurement<m>:DELay:SLOPe...................................................................................336
MEASurement<m>:ENABle <State>
Enables or disables the measurement.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
MEASurement<m>:SOURce <Source>, [<Source2>]
Defines the waveform to be measured. For delay, phase, and power measurements, 2
sources are required.
The sources can be any active input signal, math or reference waveform. Available
source waveforms depend on the measurement type, see Chapter 4.2.3, "Measure-
ment Types", on page 80.
Suffix:
<m>
.
1..4
Parameters:
<Source> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
Waveform Analysis