Rohde & Schwarz Scope Rider RTH1004 - Page 2

This manual describes the following R&S
®
RTH models with firmware version 1.70:
●
R&S
®
RTH1004 (1317.5000K04)
●
R&S
®
RTH1002 (1317.5000K02)
In addition to the base unit, the following options are described:
●
R&S
®
RTH-K1 I2C/SPI triggering and decoding (1325.9969.02)
●
R&S
®
RTH-K2 UART/RS232 triggering and decoding (1325.9975.02)
●
R&S
®
RTH-K3 CAN/LIN triggering & decoding (1333.0550.02)
●
R&S
®
RTH-K9 CAN FD triggering & decoding (1326.3829.02)
●
R&S
®
RTH-K10 SENT triggering & decoding (1326.3835.02)
●
R&S
®
RTH-K15 History and segmented memory (1326.1803.02)
●
R&S
®
RTH-K18 Spectrum analysis (1333.0680.02)
●
R&S
®
RTH-K19 Advanced trigger (1326.0642.02)
●
R&S
®
RTH-B1 Mixed signal option (1325.9981.02)
●
R&S
®
RTH-K33 Frequency counter (1333.0696.02)
●
R&S
®
RTH-K34 Harmonic analysis (1333.0673.02)
© 2018 Rohde & Schwarz GmbH & Co. KG
Mühldorfstr. 15, 81671 München, Germany
Phone: +49 89 41 29 - 0
Fax: +49 89 41 29 12 164
Email: info@rohde-schwarz.com
Internet: www.rohde-schwarz.com
Subject to change – Data without tolerance limits is not binding.
R&S
®
is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
Trade names are trademarks of the owners.
1326.1578.02 | Version 12 | R&S
®
Scope Rider RTH
Throughout this manual, products from Rohde & Schwarz are indicated without the
®
symbol, e.g. R&S
®
Scope Rider RTH is indica-
ted as R&S RTH.