Rohde & Schwarz Scope Rider RTH1004 - Page 240

Protocol Analysis
R&S
®
Scope Rider RTH
240User Manual 1326.1578.02 ─ 12
<?xml version="1.0" encoding="UTF-8"?>
<sb:LABEL-LIST-FILE>
<sb:PROJECT ID="SENT-TRANSLATION SYSTEM">
<sb:SHORT-NAME>SENT</sb:SHORT-NAME>
<sb:LONG-NAME>SENT-Translation System Demo</sb:LONG-NAME>
<sb:DESCRIPTION>This is the database for Translation demo for SENT.</sb:DESCRIPTION>
</sb:PROJECT>
<sb:FRAMES>
<sb:FRAME NAME="Air Temperature" STATE="ON">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>0</sb:ID-VALUE>
<sb:ID-LENGTH>4</sb:ID-LENGTH>
<sb:DATA-SIZE>16</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Humidity" STATE="OFF">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>2</sb:ID-VALUE>
<sb:ID-LENGTH>4</sb:ID-LENGTH>
<sb:DATA-SIZE>16</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Barometric Pressure" STATE="OFF">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>4</sb:ID-VALUE>
<sb:ID-LENGTH>4</sb:ID-LENGTH>
<sb:DATA-SIZE>16</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Configuration Code" STATE="OFF">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>04</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Manufacturer Code" STATE="OFF">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>05</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Sensor Type" STATE="ON">
<sb:DESCRIPTION>specifies the SENT Sensor Type</sb:DESCRIPTION>
<sb:ID-VALUE>03</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
<sb:SIGNALS>
<sb:SIGNAL ID="Sensor Class">
<sb:SHORT-NAME>Sensor Class</sb:SHORT-NAME>
<sb:BIT-POSITION>11</sb:BIT-POSITION>
<sb:BIT-LENGTH>12</sb:BIT-LENGTH>
<sb:BYTE-ORDER>MSB</sb:BYTE-ORDER>
<sb:VALUE-TYPE>ENUM</sb:VALUE-TYPE>
SENT (Option R&S
RTH-K10)