General Instrument Settings R&S SMC100A
1411.4060.32 4.30 E-1
Paste
Pastes the file that has been copied or cut before.
Remote-control command: n.a.
Rename
Renames the selected file or directory. The new name can be entered
in the New Filename window.
Remote-control command:
MMEM:MOVE "test02.dm_iqd","set2.dm_iqd"
Delete
Deletes the selected file. Before the file is deleted, a message
appears prompting the user to confirm deletion of the file.
Remote-control command:
MMEM:DEL '/var/test.savercl'
Create New Directory
Creates a new directory. The name of the new directory can be
entered in the New Directory window.
The directory is created as a subdirectory in the selected level.
Remote-control command:
MMEM:MDIR '/var/user/test'
Note:
When the subdirectory is entered, it is possible to enter an
absolute path name (e.g. "/var/user//meas") or the path
relative to the current directory (e.g. "../MEAS").
Factory Preset - Setup-Setting
The Factory Preset submenu provides a function to reset the instrument's settings to their factory
state. This function is activated by pressing the Execute Factory Preset button.
Note:
Since Factory Preset resets the remote channel and network settings to the default values,
executing Factory Preset via remote control terminates the connection to the instrument, if these
settings had been configured to values different to the default ones!
The Factory Preset function resets nearly all instrument settings. In addition to the regular preset by
means of the PRESET key, a Factory Preset resets also the following values:
• Reference frequency settings (Ref Oscillator menu)
• Power on settings (Level/EMF menu)
• Network settings including hostname (Setup menu)
• Remote Channel settings including IEC/IEEE-bus address and emulation (Setup menu)
• Start/Stop Gui Update (Setup menu)
• Display and keyboard settings (Setup menu).
To Next Page
Loading...
