Rohde & Schwarz SMC100A - Setting Parameters

R&S SMC100A Setting Parameters
1411.4077.62 3.15 E-1
Selecting a Unit - Setting Parameters
The entry of a numeric value can be terminated by pressing a unit key on the front panel, selecting a
unit in the selection field next to the value or by clicking the rotary knob (= Enter). The unit is assigned
i
n different ways:
Terminating the value entry by selecting a unit in the units field
When the entry is terminated by selecting a unit in the units field next to the value, the selected unit is
assigned, e.g. sym/s (for list selection see next section).
+
yields
Terminating the value entry with Enter
If an entry is terminated by clicking the rotary knob (= Enter) or with the
ENTER key, the unit displayed
in the entry field next to the value is assigned (in the example ksym/s).
+
yields
Function Front panel PC keyboard Mouse
Assigns a unit
To terminate the entry, press
one of the unit keys
or
select unit in the field at the
right of the value (for list
selection see next section).
To terminate the entry press one of the
key combinations ALT + F9/ + F10/+
F11/+ F12
or
select unit in the field at the right of the
value (for list selection see next section).
Select unit in the field at the
right of the value before
entering the value (for list
selection see next section).
Changes a unit
After the value entry has
been terminated press a unit
key
or
select unit in the field at the
right of the value (for list
selection see next section).
After the value entry has been
terminated press one of the key
combinations
ALT + F9/+ F10/+ F11/+ F12
or
select unit in the field at the right of the
value (for list selection see next section).
Select unit in the field at the
right of the value after the
value entry (for list selection
see next section).