R&S SMC100A Example of Setup
1411.4077.62 2.9 E-1
Generation of an RF Frequency Sweep Signal
In the example, an RF frequency sweep is configured. Proceed as described below:
1. Activate default (preset) state.
2. Configure and activate RF frequency sweep.
The settings are:
start frequency: 100 MHz
stop frequency: 500 MHz.
linear spacing with a step width of 1 MHz
dwell time 10 ms
single sweep mode
3. Activate RF signal.
4. Trigger single sweep
Step 1: Activate default (preset) state
Set a defined instrument state by pressing the
PRESET
key.
Step 2: Configure and activate RF frequency sweep
Select the RF block by turning the rotary knob.
Press the rotary knob to open the menu where the
RF frequency sweep menu item can be selected.
To Next Page
Loading...
