General Instrument Settings R&S SMC100A
1411.4060.32 4.22 E-1
Security - Setup-Protection
The Security... menu provides access to the passwords and mass storage security settings. It is
opened using the
SETUP key under Environment.
The menu is divided into the password sections and the security settings section. In the password
section the passwords for securing a controlled access to the instrument are defined and changed. In
the security section the remote interfaces are enabled and disabled.
A change of passwords for the operating system and security password requires the entry of the old
and new password and the conformation of the new password. All settings are only accepted after the
Accept button is pressed.
Accept - Security
Settings
Accepts a new entry or selection and changes the settings
accordingly.
Remote-control command: n.a.
User Name
Indicates the user name used for access to the operating system
Linux.
Remote-control commands: n.a.
Old password - User
Enters the currently used password. Default is "root".
Remote-control commands: n.a.
New Password - User
Enters the new password.
Remote-control commands: n.a.
Confirm New
Password - User
Enters the new password for conformation.
The new password is only valid after the Change Password button is
pressed.
Remote-control commands: n.a.
To Next Page
Loading...
