Rohde & Schwarz SMC100A - Cannot Write File (461); Driver Initialization Failed (204); File Contains Invalid Data (465); Filename Missing (463)

Alphabetical List of Device-Specific Error Messages R&S SMC100A
1411.4060.32 9.14 E-1
Cannot write file (461)
The file can not be written.
Example:
The file is read-only.
SCPI:
D
evice-specific error - sets bit 3 in the ESR register
Driver initialization failed (204)
Initialization of a driver fails when booting the instrument firmware
Example:
The driver is not compatible with the hardware or software
configuration of the instrument.
SCPI:
Device-specific error - sets bit 3 in the ESR register
File contains invalid data (465)
The selected file contains data that is not valid for the file type. The file extension
determines the data that is valid for this file type. If the file extension is changed the
lists are no longer recognized and the data are therefore invalid.
Example:
The extension of a waveform file (= *.wv) was changed to *.txt.
SCPI:
Device-specific error - sets bit 3 in the ESR register
Filename missing (463)
The desired operation cannot be execute because the file name is not specified.
Example:
A file name has to be entered when creating a new list.
SCPI:
Device-specific error - sets bit 3 in the ESR register
Hardware revision out of date (201)
A later version of certain parts of the instrument is necessary to execute the function
selected.
Example:
The driver does not support the installed version of a module.
SCPI:
Device-specific error - sets bit 3 in the ESR register