General Instrument Settings R&S SMC100A
1411.4060.32 4.8 E-1
General Configuration of Instrument - Setup Key
The SETUP key opens the Setup menu. The Setup menu is divided into several sections.
• The System section is used to set general instrument parameters.
• The Test section is used to perform function tests.
• The Environment section is used to configure the controller interfaces.
• The Remote section is used to configure the remote control interfaces.
• The Protection is used to set the protection level for service functions.
• The Settings section contains the Save/Recall menu.
Most submenus of this key can be accessed only via the
SETUP key, with the following exception:
• The Reference Oscillator submenu can also be called up in the RF block and is therefore
described in the section on this block (see section "RF Reference Frequency - Reference
Oscillator", page 4.44).
To Next Page
Loading...
