Rohde & Schwarz SMC100A - Block Diagram

R&S SMC100A Setting Parameters
1411.4077.62 3.12 E-1
Frequency/level field:
The cursor is set on the previously active menu or, if no menu was active, on the
first function block in the diagram.
Function block in the diagram:
The cursor is set on the first menu in the Winbar. If no menus are open, the current
cursor position remains unchanged.
Function Front panel PC keyboard Mouse
Edits the frequency or level
in the entry fields of the
header area
Press FREQ or LEVEL
key.
Enter value.
Press CTRL + F (frequency)
or CTRL + L (level).
Enter value.
Click the entry field and
enter value.
Activates the block
diagram
Press DIAGR key.
Press CTRL + D. Click the function block.
Activates the Winbar
Press softkey.
Press CTRL + F1... F8
Press CTRL + W.
Click button in Winbar.
Calls the Setup or File
menu or the menu tree
Press SETUP key.
Press CTRL + S (Setup) or
CTRL + M (menu tree).
-
Selecting a Control Element - Setting Parameters
Control elements are always selected in the same way no matter whether a function block in the
diagram, a menu in the menu tree, a parameter in the menu or an entry in a list or table is concerned.
• An element is activated by means of the cursor. An active element is highlighted by a blue frame.
Function Front panel PC keyboard Mouse
Selects an element
Select element by means of
the rotary knob or the arrow
keys.
Select element by means of
the arrow keys.
Click element.
Switching Parameters ON/OFF - Setting Parameters
A parameter can be activated and deactivated using a button or a check box.
The ENTER function of the different control media switches the highlighted element on or off (toggle
function). Colour and label of a button change, the check box is ticked or the tick is removed.
Function Front panel PC keyboard Mouse
Switches on/off
Press rotary knob,
ENTER key or a toggle
ON/OFF key, if
available.
Press Enter key. Click check box or button.