General Instrument Settings R&S SMC100A
1411.4060.32 4.16 E-1
Network Settings - Setup-Environment
The Network Settings... menu provides access to the network settings. It is opened using the SETUP
key under Environment. The R&S SMC is equipped with a network interface and can be connected to
an Ethernet LAN (local area network). How to connect the signal generator to the network is described
in chapter 1, section "Connecting the R&S SMC to a Network (LAN)".
NOTICE Risk of network errors!
Connecting errors may affect the entire network.
We recommend to coordinate the connection of the instrument to the network with
the network administrator.
The menu is divided into the sections Common Settings where the general network environment is
defined, IP Address section where the specific identification of the computer in the network is defined,
and DNS Server Settings where the DNS server is entered.
New entries are only accepted after the Accept button is pressed.
Accept - Network
Settings
Accepts a new entry or selection and changes the settings
accordingly.
Remote-control command:
SYST:COMM:NETW:DNS:SET
SYST:COMM:NETW:COMM:SET
SYST:COMM:NETW:IPAD:SET
To Next Page
Loading...
