R&S SMC100A General Instrument Settings
1411.4060.32 4.17 E-4
The indications of the menu are only updated after pressing the Get System Settings button.
Get System Settings
Retrieves the current system settings of the instrument.
The indications in the network menu are only updated after pressing
this button.
Remote-control command: SYST:COMM:NETW:GET
Restart Network
Shuts down the network connection of the instrument amd
subsequently re-establishes the connection. This function can be used
top solve network problems.
Note:
Only the connection of the instrument to the network restarts, the
network itself is not affected.
Remote-control command: n.a.
Hostname
Enters the individual computer name of the R&S SMC.
Note:
The computer name can only be changed after protection level 1 is
deactivated (see section "Protection - Setup-Protection")
A new entry is only accepted and the hostname changed after the
Accept button is pressed.
A predefined name is indicated and can be used for network
connections.
Remote-control command:
SYST:COMM:NETW:HOST RSSMC100A123456
MAC Address
Indicates the MAC address of the network adapter.
Remote-control command:
SYST:COMM:NETW:MAC?
To Next Page
Loading...
