Rohde & Schwarz SMC100A - Sense, Initiate and READ Subsystem

R&S SMC100A Command Description
1411.4060.32 6.23 E-1
OUTPut[:STATe]:PON OFF | UNCHanged
This command selects the state which the RF output assumes when the instrument is switched on.
The command is an event and therefore has no *RST value and no query form.
Parameters: OFF
T
he output is deactivated when the instrument is switched on.
UNCHanged
When the instrument is switched on, the output remains in the same state as it
was when the instrument was switched off.
Example:
OUTP:PON OFF
'The RF output is deactivated when the instrument is switched on.
*RST value Resolution Options SCPI
- - Device-specific
SENSe, INITiate and READ Subsystem
The SENSe subsystem contains the commands for configuring the power measurements with a R&S
NRP power sensor connected to the generator. The measurement is started and the measurement
result retrieved with the READ command. The description of this commands is included in the following.
Command Parameters Default
unit
Remark
INITiate[:POWer]:CONTinuous ON | OFF
READ[:POWer]? Query only
SENSe[:POWer]:CORRection:SPDevice:STATe ON | OFF
SENSe[:POWer]:DISPlay:PERManent:STATe ON | OFF
SENSe[:POWer]:FILTer:LENGth:AUTO? Query only
SENSe[:POWer]:FILTer:LENGth[:USER] 1 …65536
SENSe[:POWer]:FILTer:NSRatio 0.0001 … 1.0
SENSe[:POWer]:FILTer:NSRatio.MTIMe 1.0 … 999.99 s
SENSe[:POWer]:FILTer:SONCe No query
SENSe[:POWer]:FILTer:TYPE AUTO | USER | NSRatio
SENSe[:POWer]:FREQuency <frequency> Hz
Range depends on
used sensor
SENSe[:POWer]:OFFSet -100 … 100 dB dB
SENSe[:POWer]:OFFSet:STATe OFF | ON
SENSe[:POWer]:SNUMber? Query only
SENSe[:POWer]:SOURce A | USER
SENSe[:POWer]:STATus[:DEVice]? Query only
SENSe[:POWer]:SVERsion? Query only
SENSe[:POWer]:TYPE? Query only
SENSe[:POWer]:ZERO No Query
SENSe:UNIT[:POWer] DBM | DBUV | WATT DBM