R&S SMC100A General Instrument Settings
1411.4060.32 4.11 E-4
Gui Update... - Setup-System
In the Start/Stop Gui Update... menu the update of the displayed parameters can be switched off in
order to increase speed for certain settings.
Note:
It is especially recommended to switch off the GUI update for optimum sweep performance with
short dwell times and for fast settling times.
The indicated values are not updated and may therefore differ from the internally used values.
Remote-control command:
SYST:DISP:UPD OFF
Software / Options... - Setup-System
The Software / Options... menu shows the firmware version of the instrument software as well as all
installed hardware and software options.
Note:
Software options purchased at a later stage can be activated with a key code. The activation code is
supplied with the software option. How to install options is described in Chapter 4 of the Service
Manual (on CD ROM supplied with the instrument). The installation of hardware options purchased
at a later stage is also described in Chapter 4 of the Service Manual (supplied with the instrument).
Most hardware options need to be installed at an authorized Rohde&Schwarz service shop.
To Next Page
Loading...
