R&S SMC100A Example of Setup
1411.4077.62 2.5 E-1
Generation of an Amplitude-Modulated Signal
In the example, a simple AM-modulated signal is configured. Proceed as described below:
1. Activate default (preset) state.
2. Select and activate AM modulation.
3. Set frequency and level and activate RF signal.
Step 1: Activate default (preset) state
Set a defined instrument state by pressing the
PRESET key.
Step 2: Select and activate AM modulation
Select the Modulation block by turning the rotary
knob.
Press the rotary knob to open the menu where the
modulation can be selected.
The Amplitude Mod... menu is the first menu
item and is highlighted per default.
To Next Page
Loading...
