Rohde & Schwarz SMC100A - Diagnostic Subsystem

R&S SMC100A Command Description
1411.4060.32 6.9 E-1
DIAGnostic Subsystem
The DIAGnostic system contains the commands used for instrument diagnosis and servicing. SCPI
does not define any DIAGnostic commands; the commands listed here are all Device-specific. All
D
IAGnostic commands are query commands which are not influenced by *RST.
Command Parameters Default
unit
Remark
DIAGnostic:BGINfo? <module name> Query only
DIAGnostic:BGINfo:CATalog? Query only
DIAGnostic:INFO:OTIMe? Query only
DIAGnostic:INFO:POCount? Query only
DIAGnostic:POINt:CATalog? Query only
DIAGnostic<[1]|2>[:MEASure]:POINt? <point name> Query only
DIAGnostic:BGINfo? <module name>
The command checks the modules available in the instrument using the variant and revision state.
If the command is sent without parameters being specified, a complete list of all modules is returned
(the various entries are separated by commas). The length of the list is variable and depends on the
instrument equipment configuration.
If the command is sent with parameters, a list of the specified modules is returned (the various
entries are separated by commas). A list of modules names can be called up using the
DIAG:BGIN:CATalog? command .
Each entry for one module consists of four parts which are separated by space characters:
Module name Module stock number incl. variant Module revision Module serial number.
Example:
DIAG:BGIN:CAT?
'queries the instrument configuration .
Response: MBRD,....
'returns the data of all available modules.
DIAG:BGIN? 'MBRD'
'queries the configuration of the motherboard.
Response: MBRD 1234.5678.02 1.5.3 100023
'module motherboard with stock number 1234.5678.02 has revision 1.5.3 and
serial number 100023.
*RST value Resolution Options SCPI
- - Device-specific