R&S SMC100A Putting into Operation
1411.4077.62 1.13 E-1
Cleaning the Outside and Storing
W
hat is necessary is essentially the cleaning of the instrument.
NOTICE
Instrument damage caused by cleaning agents!
Prior to cleaning, disconnect the product from the AC supply.
Cleaning agents contain substances that may damage the instrument, e.g. solvent-
containing cleaning agents may damage the front panel labeling or plastic parts.
Never use cleaning agents such as solvents (e.g. diluent for lacquers, thinners,
acetone, alcohol, etc), or acids, bases, or other substances.
Use a soft, non-linting cloth to suitably clean the outside of the instrument.
EMC Safety Precautions
To avoid EMI (Electro Magnetic Interference) double shielded signal and control cables must be used at
all signal connectors.
Outputs and lines have to be terminated properly with 50 Ohms. USB devices must keep within
permissible EMI limits.
Connecting the R&S SMC to the AC Supply
The R&S SMC is automatically matched to the applied AC voltage (see rear panel). There is no need to
set the voltage manually or change fuses. The AC supply connector is on the rear of the unit (see
below).
Switching On
1. Connect the signal generator to the AC supply by means of the
supplied power cable.
Since the instrument is a protection class I equipment, it should only
be connected to a socket with a protective earth contact.
2. Press the main power switch on the rear of the instrument to
position I.
3. After power-up the instrument is either ready for operation
(STANDBY) or in operating mode, depending on the state of the
ON/STANDBY switch on the instrument front (see below).
Note:The power switch may remain on for any period of time. Switching
off is required only if the instrument should be completely isolated
from the AC supply.
4. Press the ON/STANDBY switch on the front panel; the green LED
must be on.
5. After booting the software, the instrument is ready for operation. All
modules in the instrument are supplied with power.
To Next Page
Loading...
