R&S SMC100A General Instrument Settings
1411.4060.32 4.13 E-4
Install SW-Option... - Setup-System
Newly purchased software options are enabled in the Install SW-Options... menu.. They are ready to
operate after they are enabled by means of a key code supplied with the option.
Only if the R&S SMC Signal Generator is equipped with an older firmware version, a firmware update
prior to enabling the software option may be required. The information on the valid firmware versions for
the purchased software option is provided together with the option. The firmware update is described in
the service manual instrument, chapter 4 (on CD ROM, supplied with the instrument).
Self Test
A self test is provided by the instruments´ firmware. Several diagnostic points are checked to verify the
correct values and functions of the instrument.
The Selftest... dialog is called by using the
SETUP key.
Selftest
Performs the selftest. The Testcase/Result window lists the tested
diagnostic points as well as the test results, either succeeded
(PASSED) or failed (FAILED).
Remote-control command: n.a.
To Next Page
Loading...
