Rohde & Schwarz SMC100A - RF Signal - RF; Overview of RF Signal

R&S SMC100A RF Signal - RF
1411.4060.32 4.39 E-4
RF Signal - RF
Overview of RF Signal
Settings for the RF output signal are made under "RF Signal". These settings can be accessed in the
block diagram by way of the RF function block, or by means of the menu with the same name which is
opened using the
SETUP key.
The function block is available for the basic unit (R&S SMC + frequency option R&S SMC-B10x) without
additional equipment options.
The
RF ON/OFF key can be used to activate and deactivate the output signal irrespective of the current
entry focus. The previous state is restored when the signals are reactivated.
Remote-control command:
OUTP:STAT OFF
OUTP:STAT ON
The activated and deactivated state is indicated in the block diagram by means of the different block
color and the status of the On checkbox. The disconnected connection to the output is additionally
shown when the output is deactivated. An active sweep is also indicated in the block.
The RF output state can also be set in the Configure menu of the RF block:
The CW and Sweep modes are available for generating the RF signal.
CW
The RF signal is generated with the set frequency and level. This is the default mode.
Sweep
The RF signal is generated as a sweep with the set parameters.
Instruments connected downstream can be taken into consideration when setting the frequency and
level by entering a frequency and/or level offset.