Example of Setup R&S SMC100A
1411.4077.62 2.10 E-1
Select RF Freq Sweep... by turning the rotary
knob.
Press the rotary knob to open the RF Freq Sweep
menu.
All sweep parameters are default except for the
sweep mode. The default settings are not
changed.
Select the Mode parameter by turning the rotary
knob. Press the rotary knob and select setting
Single from the list by turning the rotary knob.
Press the rotary knob, now the sweep mode is set
to single sweep from start to stop frequency.
Switch on RF frequency sweep by selecting State
On.
Now the Execute Single Sweep button to trigger
the single sweep appears.
The RF is not yet active, which means that no RF
signal is output.
To Next Page
Loading...
