R&S SMC100A Power Viewer
1411.4060.32 4.47 E-4
The menu shows the power sensor type, the measurement value and allows to configure the
measurement.
Sensor - Power
Sensors
Indicates the USB connector used for the detected sensors.
Remote-control command:
SENS:STAT?
Response. 0 (no power sensor is connected)
Response. 1 (a power sensor is connected at the USB connector)
Note:
The software version of the connected power sensor can be
retrieved by means of the remote control command:
SENS:POW:SVER?
Type - Power Sensors
Indicates the type of the connected R&S NRP power sensor. The
sensor type is automatically detected.
Remote-control command:
SENS:POW:TYPE?
To Next Page
Loading...
