Pulse Modulation R&S SMC100A
1411.4060.32 4.90 E-1
Pulse Mode - Pulse
Generator
(Source Pulse Generator only)
Selects and activates the pulse mode.
Single
A single pulse is generated in one pulse period.
Remote-control command:
SOUR:PULM:MODE SING
Double
Two pulses are generated in one pulse period.
Additional settings for the double pulse are available
in the menu.
Remote-control command:
SOUR:PULM:MODE DOUB
Pulse Period - Pulse
Generator
Sets the period of the generated pulse. The period determines the
repetition frequency of the internal signal.
Remote-control command:
SOUR:PULM:PER 0.05ms
Pulse Width - Pulse
Generator
Pulse width
Sets the width of the generated pulse. The width determines the pulse
length. The pulse width must be at least 20 ns less than the set pulse
period.
Remote-control command:
SOUR:PULM:WIDT 22ms
Pulse Delay - Pulse
Generator
(External trigger only)
Sets the pulse delay. The pulse delay determines the time that
elapses after a trigger event before pulse modulation starts. The pulse
delay is not effective for double pulse generation.
Remote-control command:
SOUR:PULM:DEL 22Ls
Double Pulse Width -
Pulse Generator
(Double Pulse only)
Sets the width of the second pulse in case of double pulse generation.
Remote-control command:
SOUR:PULM:DOUB:WIDT 33 Ls
Double Pulse Delay -
Pulse Generator
(Double Pulse only)
Sets the delay from the start of the first pulse to the start of the second
pulse.
Remote-control command:
SOUR:PULM:DOUB:DEL 22Ls
To Next Page
Loading...
