LF Generator and LF Output - Mod Gen Block R&S SMC100A
1411.4060.32 4.96 E-1
Execute Single Sweep
- LF Sweep
Triggers the sweep manually. A manual sweep can only be triggered if
Mode Single is selected.
Remote-control commands
SOUR:LFO:SWE:FREQ:MODE AUTO
TRIG0:SWE:SOUR SING
SOUR:LFO:FREQ:MODE SWE
SOUR:LFO:SWE:FREQ:EXEC
The sweep range, sweep spacing, dwell time and the external trigger slope are set in the bottom
section.
Start Freq - LF Sweep
Sets the start frequency.
Remote-control command:
SOUR:LFO:FREQ:STAR 100kHz
Stop Freq - LF Sweep
Sets the stop frequency.
Remote-control command:
SOUR:LFO:FREQ:STOP 50kHz
Current Freq - LF
Sweep
Displays the current frequency.
If Step is set, the frequency for the next frequency step of the sweep
is entered here.
Remote-control command
SOUR:LFO:FREQ:MAN 15 kHz
Spacing - LF Sweep
Selects linear or logarithmic sweep spacing.
Remote-control command:
SOUR:LFO:SWE:FREQ:SPAC LIN | LOG
To Next Page
Loading...
