R&S SMC100A Contents - Remote Control Basics
1411.4060.32 V-1 E-1
Contents - Chapter 5 "Remote Control Basics"
5 Remote Control - Basics..........................................................5.1
Introduction - Remote Control Basics............................................................... 5.1
Getting Started ................................................................................................. 5.2
Switchover to Remote Control.......................................................................... 5.2
Remote Control via IEC/IEEE Bus ...................................................... 5.3
Remote Control via LAN Interface....................................................... 5.4
Remote Control via USB Interface ...................................................... 5.9
Interface and Device Messages ....................................................................... 5.9
Interface Messages ............................................................................. 5.9
Device Messages (Commands and Device Responses) .................. 5.10
SCPI Command Structure and Syntax........................................................... 5.11
Structure of a Command Line ........................................................... 5.13
Responses to Queries....................................................................... 5.14
Parameters ........................................................................................ 5.15
Overview of Syntax Elements ........................................................... 5.17
Instrument Model and Command Processing ................................................ 5.18
Input Unit ........................................................................................... 5.18
Command Recognition...................................................................... 5.19
Database and Instrument Hardware ................................................. 5.19
Status Reporting System................................................................... 5.20
Output Unit ........................................................................................ 5.20
Command Sequence and Command Synchronization ..................... 5.21
Status Reporting System ................................................................................ 5.23
Overview of the Status Register........................................................ 5.24
Status Byte (STB) and Service Request Enable Register (SRE) ..... 5.25
IST-Flag and Parallel Poll Enable Register (PPE) ............................ 5.25
Event Status Register (ESR) and
Event Status Enable Register (ESE)................................................. 5.26
Application of the Status Reporting System...................................... 5.27
Reset Values of the Status Reporting Systems ................................ 5.28
To Next Page
Loading...
