R&S SMC100A Switchover to Remote Control
1411.4060.32 5.8 E-1
On the viWrite tab under Basic I/O, commands can be sent to the instrument; instrument
responses are displayed on the viRead tab (for further program operation refer to the online help of
the program).
4. Return to manual operation is possible via the front panel or the LAN interface.
Manually:
1. Press the
LOCAL key.
Notes:
The LOCAL key can be disabled by the universal command &LLO (see
Section "IEC/IEEE Bus Messages") in order to prevent unintentional
transition. In this case, transition to manual mode is only possible via
remote control.
The
LOCAL key can be enabled again by the interface message &NREN
(see Section "IEC/IEEE Bus Messages").
Via IEC/IEEE bus:
...
CALL IBLOC(generator%)
'Set instrument to manual operation
...
To Next Page
Loading...
