R&S SMC100A Example of Setup
1411.4077.62 2.7 E-1
Step 3: Set frequency and level and activate the RF signal
Press the FREQ key to activate the editing mode
for frequency entry. The frequency entry field in
the header section of the display is highlighted.
Enter the frequency value of the desired RF
carrier using the numeric keypad, e.g. 2 GHz.
Terminate the entry by pressing the appropriate
unit key.
Enter the level of the desired RF carrier in the
same way:
Press the
LEVEL key to activate the editing mode
for level entry. The level entry field in the header
section of the display is highlighted.
Enter the level value of the desired RF carrier
using the numeric keypad, e.g. -25 dBm.
Terminate the entry by pressing the appropriate
unit key.
To Next Page
Loading...
