Roland INTEGRA-7 - Page 19

SuperNATURAL Acoustic Tone (SN-A) – INST tab
19
• Dierences in your playing strength will smoothly change the tone character in a natural way.
• A key-o noise typical of that instrument will be heard when you release the key.
Parameter Value Explanation
Noise Level (CC16) -64–+63 Adjusts the amount of hum noise and key-o noise. Higher settings will raise the volume.
Bell/Mallet
INT: 024 Glockenspiel
INT: 025 Vibraphone
INT: 026 Marimba
INT: 027 Xylophone
INT: 028 Tubular Bells
ExSN1: 001 Santoor
ExSN1: 002 Yang Chin
• You can play a roll by operating the Modulation controller (CC01) while playing a note.
• You can produce a glissando eect by operating the pitch bend lever while holding down a note, or by playing legato with the Portamento SW (CC65)
turned on.
• If Bend Range is set to Tone, you can produce a glissando eect by operating the pitch bend lever.
• If Bend Range is set to anything other than Tone, this eect will be obtained if Bend Mode (CC19) is turned on.
Use this when you want to switch between glissando playing and conventional pitch change.
• By using CC18, you can simulate the following technique.
INT: 024–028: the technique of using your hand or mallet to mute the vibration (sound).
ExSN1: 001–002: the technique of playing a rapid and delicate roll (Slide Roll)
Parameter Value Explanation
Mallet Hardness (CC16) -64–+63 Adjusts the hardness of the mallet. Higher settings produce the sound of a harder mallet.
Roll Speed (CC17) -64–+63 Adjusts the speed of the roll eect.
Variation Refer to p. 28. Performance variation sounds
Organ
INT: 029 TW Organ
• The sound will be unaected by the strength with which you play the keyboard.
• This allows you to use the nine harmonic bars to create your sound just as on a tone wheel organ.
Parameter Value Explanation
Harmonic Bar 16' 0–8
Adjust the level of each footage.
A dierent harmonic component is assigned to each footage; the sound of the organ is
created by mixing these components.
The 8’ footage is the core of the sound; this is the basic pitch around which the sound is
created.
* Harmonic Bar 1’ is unavailable if Percussion Switch is on.
Harmonic Bar 5-1/3' 0–8
Harmonic Bar 8' 0–8
Harmonic Bar 4' 0–8
Harmonic Bar 2-2/3' 0–8
Harmonic Bar 2' 0–8
Harmonic Bar 1-3/5' 0–8
Harmonic Bar 1-1/3' 0–8
Harmonic Bar 1' 0–8
Leakage Level 0–127
Noise Level at which the signal of tone wheels unrelated to the pressed keys is mixed into
the input
Percussion Switch OFF, ON If this is on, a crisp attack will be added to the beginning of the notes.
Percussion Soft NORM, SOFT
NORM: The percussion sound will be at the normal volume, and the sound of the harmonic
bars will be reduced.
SOFT: The percussion sound will be reduced, and the harmonic bars will be at the normal
volume.
Percussion Soft Level 0–15 Volume of the percussion sound when Percussion Soft is set to SOFT
Percussion Normal Level 0–15 Volume of the percussion sound when Percussion Soft is set to NORM