EasyManua.ls Logo

Roland INTEGRA-7 - Panel Descriptions; Front Panel Controls

Roland INTEGRA-7
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SuperNATURAL Acoustic Tone (SN-A) – INST tab
20
Parameter Value Explanation
Percussion Slow FAST, SLOW
FAST: The percussion sound will disappear immediately, producing a sharp attack.
SLOW: The percussion sound will disappear slowly, producing a more gentle attack.
Percussion Slow Time 0–127 Decay time of the percussion sound when Percussion Slow is set to SLOW
Percussion Fast Time 0–127 Decay time of the percussion sound when Percussion Slow is set to FAST
Percussion Harmonic 2ND, 3RD
2ND: The percussion sound will be the same pitch as the 4’ harmonic bar.
3RD: The percussion sound will be the same pitch as the 2-2/3’ harmonic bar.
Percussion Recharge Time 0–15
Normally, the percussion sound will be added only to the rst note of successive notes
played legato.
This reproduces the characteristics of the analog circuitry that produced the percussion
sound in tone wheel organs, which caused the percussion sound to be softer when keys
were pressed in quick succession. This species the characteristics of this analog circuit.
Percussion Harmonic Bar Level 0–127
The volume of the organ will be reduced if Percussion Soft is set to NORM.
This species how much the volume will be reduced.
Key On Click Level 0–31 Level of the key-click when a key is pressed
Key O Click Level 0–31 Level of the key-click when a key is released
Accordion/Harmonica
INT: 030 French Accordion
INT: 031 Italian Accordion
INT: 033 Bandoneon
Varying your keyboard playing dynamics will create volume changes as if you were using the bellows.
If Bend Range is set to Tone, moving the pitch bend lever upward will produce a tremolo eect, as if you were moving the bellows in small steps.
If Bend Range is set to anything other than Tone, this eect will be produced if Bend Mode (CC19) is turned on.
Use this when you want to switch between the tremolo eect and conventional pitch change.
Parameter Value Explanation
Noise Level (CC16) -64–+63 Adjusts the amount of key noise heard when you press or release a key.
INT: 032 Harmonica
If Bend Range is set to Tone, moving the pitch bend lever upward will produce a wah eect as if you were using your hands to enclose the harmonica.
If Bend Range is set to anything other than Tone, this eect will be produced if Bend Mode (CC19) is turned on.
Use this when you want to switch between the wah eect and conventional pitch change.
Parameter Value Explanation
Noise Level (CC16) -64–+63 Adjusts the amount of breath noise.
Growl Sens (CC18) 0–127 Adjusts the distinctive nuance (growl) of the breath noise.
Ac.Guitar
INT: 034 Nylon Guitar
INT: 035 Flamenco Guitar
INT: 036 SteelStr Guitar
ExSN3: 001 TC Guitar w/Fing
ExSN3: 002 335Guitar w/Fing
ExSN4: 001 Ukulele
ExSN4: 002 Nylon Guitar 2
ExSN4: 003 12th Steel Gtr
ExSN4: 005 SteelFing Guitar
ExSN4: 006 SteelStr Guitar2
Rapid legato playing in an interval of two semitones or less will produce either a slide or a hammering-on eect, depending on how fast you play.
If Strum Mode is o, playing an arpeggio with the Hold pedal held down will produce an arpeggio eect typical of a guitar.
If Strum Mode is on, playing a chord with the Hold pedal held down will produce a guitar-like chordal performance.
Note numbers 34 and lower will produce ghost notes as played on a guitar.

Table of Contents

Other manuals for Roland INTEGRA-7

Related product manuals