187
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
The function buttons have the following operations:
*1 Not shown in the ALL UNITS tab.
*2 Not available if [F7 (MEMORY SAFE)] is on.
1.
Access the M-48 MEMORY popup.
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
on).
3.
Press [F5 (STORE)].
fig.ScrM48MemStore.eps
The M-48 MEMORY STORE popup will appear.
4.
Edit the name in the name edit field, and press
[F8 (STORE)].
fig.ScrM48MemStore_Conf.eps
A message will ask you to confirm the store operation.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
5.
Press [F8 (STORE)].
The M-48’s current memory settings will be stored to the
memory you selected in step 2, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
1.
Access the M-48 MEMORY popup.
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
turned on).
3.
Press [F4 (RECALL)].
fig.ScrM48MemRecall_Conf.eps
A message will ask you to confirm the recall operation.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
4.
Press [F8 (RECALL)].
The memory you selected in step 2 will be recalled to the M-
48’s current memory, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
1.
Access the M-48 MEMORY popup.
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
turned on).
3.
Press [F6 (CLEAR)].
fig.ScrM48MemClr_Conf.eps
A message will ask you to confirm the operation.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
4.
Press [F8 (CLEAR)].
The contents of the memory you selected in step 2 will be
cleared, and the memory will be initialized.
Pressing [F7 (CANCEL)] will cancel the operation.
[F1 (SELECTED UNIT)]
Shows the SELECTED UNIT tab.
[F2 (ALL UNITS)] Shows the ALL UNITS tab.
[F3 (NAME EDIT)]
*1 *2
Accesses the NAME EDIT popup where you can
edit the memory name.
[F4 (RECALL)]
*2
Recalls the memory number selected in the list
(p. 187).
[F5 (STORE)]
* 2
Accesses the M-48 MEMORY STORE popup,
where you can store to the memory number
selected in the list (p. 187).
[F6 (CLEAR)]
*2
Returns the contents of the memory selected in
the list to the default state (p. 187).
[F7 (MEMORY SAFE)]
*1
Turns MEMORY SAFE on/off for the target M-48
unit.
[F8 (CLOSE)] Closes the popup.
Storing the M-48’s current memory
Recalling a memory to the M-48
Clearing the contents of an M-48 memory
M-480_e.book 187 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
