EasyManua.ls Logo

Roland M-480 - Page 218

Roland M-480
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
218
Appendix
Appendix
PAN HEAD LONG
Panning of the long playback head
Value: L63–C–R63
TAPE DIST (Tape Distortion)
Adds distortion typical of a tape
Value: 0–100
WOW and FLUTTER RATE
Speed of pitch modulation caused by tape aging and uneven
rotation
Value: 0–100
WOW and FLUTTER DEPTH
Depth of pitch modulation caused by tape aging and uneven
rotation
Value: 0–100
REVERB
REVERB STEREO Sw (Reverb Stereo Switch)
Specifies whether the reverb sound will be output in stereo
Value: OFF, ON
REVERB VOL (Reverb Volume)
Level of the reverb sound
Value: 0–100
fig.ScrSBF325.eps
This is a stereo-in, stereo-out flanger that models the Roland SBF-
325 Stereo Flanger.
FEEDBACK
Amount of flanger sound returned to the input (valid only if
EFFECT MODE is set to FLANGER)
Value: 0.0–10.0
EFFECT MODE
Value
FLANGER I: Monaural mode flanger
FLANGER II: Stereo mode flanger
FLANGER III: Cross-mix mode flanger
OFF: Modulation off
CHORUS: Chorus
CH-B MOD (CH-B Modulation)
Specifies whether the channel B flanger effect will be inverted
Value: NORM, INV
CH-A
Specifies whether the channel A flanger sound will be phase-
reversed
Value: NORM, INV
CH-B
Specifies whether the channel B flanger sound will be phase-
reversed
Value: NORM, INV
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value: OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value: OFF, ON
LEVEL
Output level
Value: 0–100
fig.ScrSPH323.eps
This is a phase shifter that models the Roland SPH-323 Phase
Shifter. The original was mono-in, mono-out, but this modeling is
a dual-mono design with two units in parallel. The MOD LINK Sw
allows you to use this as a stereo-in, stereo-out effect.
CENTER FREQ (Center Frequency)
Center frequency at which the phaser effect is applied
Value: 0–100
RESONANCE
Boosts the region around the center frequency specified by
CENTER FREQ
Value: 0.0–10.0
SHIFT MODE
Specifies the number of stages for the phaser
Value: 8STAGE, 4STAGE
SBF-325 (STEREO FLANGER SBF-325)
SPH-323 (PHASE SHIFTER SPH-323)
M-480_e.book 218 ページ 2011年3月2日 水曜日 午前9時20分

Table of Contents

Other manuals for Roland M-480

Related product manuals