Roland M-480 - Page 219

219
Appendix
Appendix
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value: OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value: OFF, ON
LEVEL
Output level
Value: 0–100
MOD LINK Sw (Modulation Link Switch)
Specifies whether the modulation of the two SPH-323 units will
be linked
Value: OFF, ON
CH-B MOD (CH-B Modulation)
Specifies whether the phase of the modulation for channel B
(the lower SPH-323) will be inverted
Value: NORM, INV
MODULATION
LFO1 DEPTH
LFO1 modulation depth
Value: 0.0–10.0
LFO1 RATE
LFO1 modulation rate
Value: 0–100
LFO2 DEPTH
LFO2 modulation depth
Value: 0.0–10.0
LFO2 RATE
LFO2 modulation rate
Value: 0–100
fig.ScrSDD320.eps
This is a stereo-in, stereo-out chorus that models the Roland SDD-
320 Dimension D.
The SDD-320 was released in 1979, and became standard
equipment in many recording studios.
DIMENSION MODE
Specifies how the chorus changes
Value: OFF, 1, 2, 3, 4, 1+4, 2+4, 3+4
1+4, 2+4, and 3+4 can be selected by pressing [F1 (1+4)], [F2
(2+4)], or [F3 (3+4)], respectively.
INPUT MODE
Input signal stereo/mono setting
Value: MONO, STEREO
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value: OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value: OFF, ON
LEVEL
Output level
Value: 0–100
SDD-320 (DIMENSION D SDD-320)
M-480_e.book 219 ページ ２０１１年３月２日 水曜日 午前９時２０分