48
Input channel operations
Input channel operations
Insert indication
fig.ScrChIns.eps
FX INS
If FX1–FX6 are inserted, the number of the inserted FX is
shown here.
If the number is shown in white, the effect insertion is
enabled. If it is shown in gray, effect insertion is bypassed.
By moving the cursor to FX INS and press [ENTER], you can
access the FX 1–6 tab of the EFFECTS screen will appear.
Inserting an effect into a channel is done in the EFFECTS screen.
For details, refer to “Inserting an effect into a channel” (p. 101).
Up to six effects can be inserted into one channel. In this case,
they will be inserted in series, in order of the FX number.
EXT FX
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you
can access the EXT FX 1–6 tab or EXT FX 7–8 tab of the
EFFECTS screen.
Inserting an external effects processor into a channel is done in
the EXTERNAL INSERT screen. For details, refer to “Inserting an
EXT FX into a channel” (p. 111).
DELAY
fig.ScrChDelay.eps
DELAY button
This turns the delay on/off.
DELAY TIME
This indicates the delay time in milliseconds.
DELAY knob
This adjusts the amount of delay in a range of 0.0 ms–400.0
ms (when delay unit is millisecond).
You can select one of the following delay units (p. 156):
4-band EQ
fig.ScrChEQ.eps
EQ button
This turns the 4-band EQ on/off.
4-band EQ graph
This shows the approximate response of the 4-band EQ.
OL (Overload) indicator
This will light red when the output of the 4-band EQ exceeds
the OVER Lev setting specified in the METER SETUP popup
(p. 96).
TYPE
These select the filter type from the following choices:
Q knobs
These adjust the Q in a range of 0.36–16. Higher values will
produce a sharper curve.
This is not shown when LSV, HPF1, HSV, or LPF1 is selected as
the filter type.
FREQ knobs
These adjust the frequency in a range of 20 Hz–20.0 kHz.
GAIN knobs
These adjust the gain in a range of -15.0 dB– +15.0 dB.
This is not shown when HPF1, HPF2, BPF, NOTCH, LPF1, or LPF2
is selected as the filter type.
For details, refer to “4-band EQ operations” (p. 82).
ms
millisecond
ft Feet
m Meter
F Frame (24, 25, 29.97, 30fps)
6
1
2
1
2
7
1 2 3
1
2
3
Type
Function Desc.
LSV
Low shelving LO only
HPF1 -6 dB/oct high-pass filter
HPF2 -12 dB/oct high-pass filter
PEAK Peaking
BPF Band-pass filter
NOTCH Notch filter
HSV High shelving HI only
LPF1 -6 dB/oct low-pass filter
LPF2 -12 dB/oct low-pass filter
8
1
2
3
4
5
6
7
1
2
3
4
5
6
7
M-480_e.book 48 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
