2-2 Loading and Cutting Off Media
33
Chapter 2 Operation
4.
Install the media clamps and close the front cover.
➊
Install the media clamps.
The media clamps have distinct left and right sides.
Install them as shown in the figure.
Line up the hole with the end of the media
➋
Close the front cover.
➌
Use to select "ROLL."
Press
.
➍
Press .
Important Note When Using the Media Clamps
Insert the media clamps firmly all the way until they engage with an audible click, and make sure they will not come
loose. Incorrect mounting may cause the media to catch or snag and make correct printing impossible, or may lead to
malfunction or poor output quality.
Media clamp Media clamp
Front cover
SETUP SHEET
ROLL
To Next Page
Loading...
