2-2 Loading and Cutting Off Media
32
Chapter 2 Operation
➋
Secure the stoppers in place in alignment with the width of the media.
The stoppers number four in total. Tighten all screws.
Important
Make sure the media flanges are straight. Correct media feed is impossible if either of the media flanges is at an
angle.
3.
Load the media so that it is without slack.
➊
Pull out the media.
Hold the media at the center and pull it out, being
sure to keep it straight.
Make sure all areas of the media are taut.
➋
Pull back the loading lever to secure the media
in place.
Tighten the screws
to secure in place.
Stopper
Loading lever
Stopper
Roll media
OK Not OK
OK Not OK
To Next Page
Loading...
